Hi Everyone,
I am currently trying to correct some errors in a driver project that causes the driver to fail
-4 tests in group G
-3 tests in group J
-1 test in group K
-4 tests in group N
So I am trying to limit the number of tests ran to just the failing ones. I had a quick scan through the code and discovered the “-f” option, so i created the file “test_set” with the following entries:
"
N10101
N10201
"
and then I ran ./generator -v 2 -f test_set
this reported only tests in group N, but they were all being skipped.
I carried on and tried ./report -v 2 (as -f seemed to be a “bad option”) and it came up that lots of test from Group A failed without showing anything from group N.
what am I missing? is there an option for report that I should add that i haven’t done? Is there any documentation on running tests that i have not come across yet?
I appreciate any time you can spare to enlighten me
-Thanks, Chris